Gas Filling Inside Flat Press Production Line

LBW2000PC Vertical Automatic Insulating Glass Gas Filling Inside Flat Press Multifunction Production Line



Structure and Function for Each Part
This production line is composed of feed section, washing and drying section, transition and storage section, light inspection section and spacer bar location section, outside assembly section, inside flat press section, and storage section.
This line is controlled by PLC and realizes the automatic control and frequency control of the motor speed of the whole line. It adopts advanced assembly technique and solves the problems of uneven press and misplacement of the glass. The assembly section adopts limit switch and cylinder tank whose travel distance can be adjusted, making the operation easy and the location precise and the movement reliable.
There are two operation methods in the control panel: 'automatic' and 'manual'. If the separate operation of each section or maintenance is needed, the 'manual' operation method is needed.
Secotion1: Feed Section:
It is the first section of the line and its main function is to transmit the glass to the washing and drying section.
LOW-E glass automatic diagnosis system can easily know whether low-E glass putting is right or not. When is wrong, the alarm will raise the alarm, and worker can change it immediately. This system prevents the membrane of coating glass (especially the LOW-E glass) from being destroyed, the glass input conveyor station is loaded with the coating glass automatic diagnosis system, fully guaranteed the correct washing and covering of the coating glass.
Section2:Washing and Drying Section:
Washing part:This part has three pairs of brushes (the material is high -temperature nylon wire ) and a pair of sponge roller. The brushes are driven by three synchronous motors separately and the movement is stable. Three pairs of tubular rollers type of hair brushes, use High Temperature Resistant and soft nature hair brush, fully guaranteed the coating glass especially the LOW-E glass layer stratification can't be destroyed.

Section3: Transition and Storage Section:
This section is used to transmit and store the glass to improve the work efficiency.
Section4. light inspection section and spacer bar location section
This section is used to inspect the washing and drying quality of the glass. The lights are put perpendicularly with the glass and the back board is painted black. It is easy to check the washing and drying effect. When the back end of the glass passes the photoelectric switch, the transmission speed will increase automatically.
Section5.Outside Assembly Section
These two wheels are controlled by Airtac cylinder, and they can easily push the glass tightly together.
The sensor can easily know the glass position and stop at right place when glass coming from the light and aluminum bar installation section.
Section 6.Inside Flat Press Section
10.1 In this section, the back board is steel plate with spraying plastic. Plate board is high density board with film, can be waterproofed, non-deformation, can bear beat.
10.2 Adopts imported high quality vacuum generator, it can keep pressure more than 0.8Mpa, and also can automatically adjust the sucker's power, avoid glass falling down.
10.3 This section can be opened to check and maintain. There are lifting up device, avoid misplacement of two or three glass, especially for big glass. There are straight line guide rail, it can guarantee glass press parallel with high accuracy.

Section7. Transition and Storage Section:
This section is used to transmit and store the glass to improve the work efficiency
Technical paramete

Detail Photos

double glass machine

double glazing equipment

Gas Filling Inside Flat Press Production Line Images